A synthetic blend containing the purest, sub-micron
molybdenum disulfide available. It is formulated specifically for firearms
and military hardware. Tested and used by NAVY SEALs, it lubricates and
protects from -65ºF/-54°C to 650ºF/343°C and resists water wash-off. Even
under extreme conditions and high load, it prevents galling of all metals
including titanium, aluminum and stainless steel. 12cc #91050
HI-SLIP GREASE HI-SLIP GREASE offers the beneficial properties of conventional
oil based lubricants without the migration problems; it stays right where
you put it. Packaged in a handy syringe, application to any surface is easy.
This product incorporates the latest synthetic and dry film molybdenum disulfide
technology to extend its functional range from the standpoint of both temperature
and load carrying ability.
HI-SLIP GREASE should be used on all high load surfaces such as locking
lugs on bolts. It smoothes tight actions for an easy lock up, lightens triggers
and protects choke tube threads, while making them easier to tighten and
remove.
HI-SLIP GREASE can be used on firearms, fishing tackle, knives and tools
and around the house; anywhere heavy-duty lubrication and protection is
needed.
How it Works:
HI-SLIP GREASE works by sticking right where it is applied. Sentry Solutions
formulated this product with just the amount of "tackiness" to resist any
migration and resist water wash off. Using the handy syringe you can apply
precisely the amount needed and know that it will not spread to other areas
of your firearms or equipment. When used in combination with Sentry Solutions'
dry film products (like SMOOTH-KOTE and BP2000 Powder) you are able to tune
your firearms for the highest performance and reliability.
HI-SLIP GREASE provides a high performance grease film and an extreme pressure-lubricating
layer between surfaces and wear points where galling may occur. It works
especially well on highly loaded components, including those made of titanium
and aluminum. It will lubricate and protect all kinds of equipment not only
in sub-zero Arctic temperatures (-65°F/-54°C), but also in the hottest desert
environments (650ºF/343°C), and it is extremely resistant to water.
Directions :
- Clean surfaces well.
- Apply a small amount of HI-SLIP GREASE (about the size of a pen tip) with
the syringe applicator exactly where you want it.
- Wipe off any excess. Pull back on syringe plunger to draw grease out of
nozzle and replace cap.
When applying to larger surfaces such as slide rails or threads on choke
tubes, use a swab or similar to spread a thin film on the areas to be protected.
Always wipe off any excess to avoid mess and contamination of surrounding
areas. |
